Descriere The DYNACORD FX 20 is a Planar Waveguide Basshorn, equipped with the high-power Electro-Voice EVX 180B 18" transducer. Frequency response is 30Hz - 150Hz (-10dB), so the crossover frequency to Mid-Hi cabinets can be chosen strictly application-oriented between 80Hz and 140Hz. The cabinet is equipped with an electronic circuit called VOICE COIL TRACKING PROTECTION. This circuit senses the terminal voltage of the transducer and simulates the thermal behaviour of the woofer´s voice coil. In case of potential thermal overload the power applied to the speaker is reduced to a safe level. Power amps up to 1200W/8Ohms can be used in order to have maximum dynamic range without the danger of thermal overload in non-controlled situations. The VOICE COIL TRACKING PROTECTION exhibits "soft" switching characteristics, so no annoying clicks or pops are audible. The circuitry automatically resets after the voice coil temperature has reached a safe value. The FX 20 cabinet is made of 15mm poplar plywood. All corner joints and braces are grooved and glued. The cabinet surface is covered with a heavy-duty black carpet. A powder- coated steel grille and an acoustic foam front protects the speakers. The connector panel uses two 4-pole Speakon connectors (IN/OUT) for a safe connection and easy daisy-chaining to other cabinets. The pin assignment is 1+/1-. Pins 2+ and 2- are also connected between the respective two Speakon connectors. When using DYNACORD power amp racks or system amplifiers, the whole system can be wired with 4-pole Speakon cables without any danger of accidental wiring mistakes. The cabinet is equipped with eight large rubber feet that allow easy stacking. Six handles and four heavy-duty castors on the rear side guarantee easy and safe transport.
Specificatii tehnice

Cabinet Subwoofer

Configuration Planar waveguide basshorn

Nominal Impedance 8 Ohms

Rated Power RMS 600 W

Program Power 1200 W

SPL 2,83V / 1m 1W/8 Ohms 101 dB

Max SPL 1m (calculated) 132 dB

Frequency Response (-10 dB) measured with Xa4000 30 Hz -150 Hz

Recommended Active Crossover Frequency to Subwoofer 140 Hz / 18 dB/Oct. Butterworth

Voice Coil Tracking Protection Yes

Components EVX 180 B

Connector Wiring 4-pole 1+/1-

Connector Model Speakon 2 x NL4MPR

Dimensions 610 x 905 x 814 mm

Net Weight 47,5 kg

Enclosure Material Poplar plywood 15 mm

Finish Heavy-duty black carpet

Grille Acoustic foam, powder coated steel

Handles 6

Castors 4



Denumiri similare la Monitor de scena Dynacord Forum Line FX 20: ForumLineFX20

Galerie